Company


February 1, 2017

How to Move Elements Linearly in RISAFloor

RISAFloor Version 11 added the ability to reposition selected elements such as beams, columns, walls, and joints in your model. On the Graphic Editing Toolbar, click on the Move Selected Items RISAFloor Move tool 1 button to open the Move Selected Items dialog box.

RISAFloor Move tool 2

Move by Point Location option allows the user to click on the first point and then click on the second point to define the distance to move the selected items. In the example below, the Move by Point Location option is selected. With N4 highlighted, the first click is on N4 and then the second click is on project grid line C3, which modes the wall panels associated with that end node. The beam ends did not move because their end nodes were not selected. In this case, a good option is to use the Trim and Extend  tools to clean up any framing discontinuities.

RISAFloor Move tool 3

Move Distance lets you to enter in the increments for the distance entered in the X and Y directions. For example in the below image, the selected beam and column are moved by entering in a distance of 10’ in the X direction. When elements such as beams and walls are moved, the end joints associated with them move as well. If the joint is also shared by a column, that column will move along with everything attached to the column.

RISAFloor Move tool 4

Move at an Angle selection will move the selected elements at an angle from the horizontal axis by an offset distance both entered by the user. For example, in the model below, the three selected columns and their nodes are moved at an angle of 45 degrees from horizontal and offset by five feet. This also repositions the beams connected to those columns because that column node is also associated with the beam end node.

RISAFloor Move tool 5

 


Tags:

This entry was posted by RISA News on Wednesday, February 1st, 2017 at 3:05 pm and is filed under Technical Solutions. You can follow any responses to this entry through the RSS 2.0 feed. Both comments and pings are currently closed.

Comments are closed.