Company


May 24, 2010

How to Define a Beam to Column Eccentricity in RISA-3D & RISA-2D

When you have a deep column, it is necessary to model the beam so that it connects to the face of the column. This results in an eccentricity at the joint. RISA-3D and RISA-2D offer two ways to model this eccentricity.

Open the Members Spreadsheet and go to the Advanced tab.  There are two options labeled I Offset and J Offset. These represent the offset at the start (I) and end (J) of the member, respectively.

Column-Eccentricities_1
For the beam member you can either enter the exact value of the member offset (i.e. half the depth of the column) or you can enter the column member number. If you enter the column member number the program will automatically calculate the offset assuming half the column depth. This feature is very useful because it will automatically update the offset value when you change the column size.

Please note that using the offset feature will reduce the total length of your beam by the offset amounts which will affect your design code check calculation.

For example, in a portal frame model where M1 is the beam and M2 and M3 are 24 inch deep columns, there are two options for offsets that will produce the same results: 12 inches or M2.

Column-Eccentricities_2

Column-Eccentricities_3


Tags: ,

This entry was posted by RISA News on Monday, May 24th, 2010 at 9:00 am and is filed under Technical Solutions. You can follow any responses to this entry through the RSS 2.0 feed. Both comments and pings are currently closed.

Comments are closed.